Chrysler 1998 Voyager Service Manual page 396

8E - 24 INSTRUMENT PANEL AND SYSTEMS
REMOVAL AND INSTALLATION (Continued)
INSTALLATION
The inner and outer louvers have different size
pivot pins on the housing. The outer housing has a
larger pin on the right side then the inner housing
(Fig. 33). The louver have a surface cut out on the
right side of the housings to note the proper side.
(1) The right pivot pin is slotted on both housings.
So when aligning louver tab with the pin ensure that
they are lined up.
(2) Using care, apply pressure on outer edge of the
louver and push into place.
(3) Rotate louver to ensure proper engagement.
Fig. 33 Passenger Side Louver and Housings
PASSENGER SIDE LOUVER OUTER HOUSINGS
REMOVAL
(1) Using a trim stick, insert trim stick between
the outer edge of the housing and the pad/panel vinyl
covering (Fig. 34).
(2) Lightly pry housing inward and by hand pull
the housing free from panel (Fig. 35).
INSTALLATION
(1) Place the slotted pin on the right side of the
opening.
(2) Set housing in to position and push into place.
The housing may need to be rocked to get the best fit
within the opening.
INSTRUMENT PANEL TOP COVER
REMOVAL
(1) Remove A-pillar trim.
(2) Using a trim stick, disengage clips holding rear
edge of top cover to instrument panel (Fig. 36).
(3) Disconnect wire harness from message center.
(4) Pull top cover rearward to disengage hooks
holding front of top cover to instrument panel.
(5) Remove top cover.
Fig. 34 Remove Housing
Fig. 35 Housing Being Removed
Fig. 36 Instrument Panel Top Cover
NS/GS