Chrysler 1998 Voyager Service Manual page 538

8R - 10 POWER SEATS
SERVICE PROCEDURES (Continued)
LOCATION
CAVITY #8
CIRCUIT P26
CAVITY #7
CIRCUIT P27
CAVITY #18
CIRCUIT P25
CAVITY #17
CIRCUIT P47
Memory Seat/Mirror Module in the recall mode to
the values that are stored in the module's memory.
(8) Whenever the module receives a specific data
stream from the RKE receiver that involves the pro-
gramming of a new transmitter into the RKE
receiver, the module will clear its nonvolatile memory
seat and recliner values for both memory 1 and 2
and will default to a location consisting of seat track
rearward, seat vertical risers down, and recliner for-
ward in both memory 1 and 2. After this has
occurred, the customer must reprogram their desired
seat and mirror positions.
(9) A recall is possible any time that the vehicle
transmission is in PARK. This condition is monitored
by the Body Control Module (BCM).
(10) A ground placed on the serial data link by the
BCM whenever that the transmission is not in
PARK, will inhibit a recall request from the door
mounted memory switch 1 or 2 or the RKE receiver
that was initiated by either of the validly pro-
grammed transmitters.
NOTE: The module will abort a recall if the trans-
mission is moved out of the PARK position or if any
seat, recliner or memory switch is pressed.
SEAT ACTUATIONS TABLE
POSITION
SEAT TRACK FRONT UP
SEAT TRACK FRONT DOWN
SEAT TRACK REAR UP
SEAT TRACK REAR DOWN
TRACK HORIZONTAL FORWARD
TRACK HORIZONTAL REARWARD
RECLINER FORWARD
RECLINER REARWARD
VOLTAGE READING
VOLTAGE INCREASES
VOLTAGE DECREASES
VOLTAGE INCREASES
VOLTAGE DECREASES
VOLTAGE INCREASES
VOLTAGE DECREASES
VOLTAGE INCREASES
VOLTAGE DECREASES
REMOVAL AND INSTALLATION
MEMORY SWITCHES
REMOVAL
(1) Insert a proper tool through the access slot
located at the front forward edge of the switch bezel.
(2) Pry the switch out from the door trim panel
opening.
(3) Disconnect wire connector from back of switch.
INSTALLATION
For installation. reverse the above procedures.
SEAT TRACK ASSEMBLY
Refer to Group 23, Body for Removal and Installa-
tion procedures.
NS