8D - 36
IGNITION SYSTEM
REMOVAL AND INSTALLATION (Continued)
REMOVAL
(1) Disconnect negative cable from battery.
(2) Remove steering column cover retaining screws
(Fig. 3).
Fig. 3 Steering Column Cover
(3) Remove parking brake release cable from han-
dle (Fig. 4).
Fig. 4 Parking Brake Release Cable
(4) Remove
screws
shrouds (Fig. 5) and remove lower shroud.
(5) Place key cylinder in RUN position. Depress
lock cylinder retaining tab and remove key cylinder
(Fig. 6).
(6) Remove ignition switch mounting screw (Fig. 7)
with a #10 Torx tamper proof bit.
holding
steering
column
Fig. 5 Steering Column Shroud Screws
Fig. 6 Lock Cylinder Retaining Tab
(7) Depress retaining tab (Fig. 3) or (Fig. 8) and
gently pry ignition switch from steering column (Fig.
9).
(8) Disconnect electrical connectors from ignition
switch and remove switch (Fig. 10).
NS