Instrument Panel Left End Cover; Instrument Panel Louvers - Chrysler 1998 Voyager Service Manual

8E - 22 INSTRUMENT PANEL AND SYSTEMS
REMOVAL AND INSTALLATION (Continued)
(29) Remove the bolts holding the instrument
panel frame to the brackets on cowl side panels (Fig.
27) and (Fig. 28).
Fig. 27 Passenger Side Instrument Panel
Fig. 28 Driver's Side instrument Panel
(30) Loosen, but do not remove, the pivot bolts
holding the instrument panel to the cowl panels.
(31) Remove the bolts holding the instrument
panel frame to the dash panel below windshield
opening.
(32) Remove the instrument panel from vehicle.
INSTALLATION
For installation, reverse the above procedures.

INSTRUMENT PANEL LEFT END COVER

REMOVAL
(1) Open driver side front door (Fig. 29).
Fig. 29 Instrument Panel Left End Cover
(2) Remove lower steering column cover as neces-
sary to gain clearance for end cover removal.
(3) Remove attaching screw
(4) Disengage clips holding end cover to instru-
ment panel.
(5) Remove instrument panel end cover and foam
pad covering the A/C inlet projection of the end cover
if equipped.
INSTALLATION
For installation, reverse the above procedures.

INSTRUMENT PANEL LOUVERS

CENTER LOUVER HOUSING
REMOVAL
(1) Remove the instrument cluster bezel. Refer to
Instrument Cluster Bezel removal and installation
procedures.
(2) Place cluster bezel on a clean surface face down
with the head lamp switch to the right side (Fig. 30).
(3) Using a flat bladed tool, release the louver
housing locks tabs (Fig. 31).
(4) Release the upper left lock tab first, then the
two lower louver tabs.
NS/GS