Specifications Generator; Torque - Chrysler 1998 Voyager Service Manual

NS
REMOVAL AND INSTALLATION (Continued)
(2) Install bolt to hold bottom of generator to lower
pivot bracket.
(3) Place B+ terminal in position on generator.
(4) Install nut to hold B+ wire terminal to back of
generator.
(5) Connect the push-in field wire connector into
back of generator.
(6) Rotate generator forward away from dash
panel.
(7) Place generator mount bracket in position on
vehicle.
(8) Install bolt to hold top of generator to mount
bracket.
(9) Install bolts to hold outside of generator mount
bracket to generator mount plate.
(10) Install bolt to hold top of generator mount
bracket to engine air intake plenum.
(11) Install accessory drive belt, refer to Group 7,
Cooling System for proper procedures.
(12) Install windshield wiper housing, refer to
Group 8K, Windshield Wipers and Washers for
proper procedures.
(13) Connect battery negative cable.
(14) Verify generator charge rate.
CHARGING SYSTEM
SPECIFICATIONS
GENERATOR
Type
Nippondenso 90 A
HS
Nippondenso 120 A
HS
Part number is located on the side of the generator.

TORQUE

DESCRIPTION
Battery Hold Down Bolt . . . . . . .14 N·m (125 in. lbs.)
Generator Mounting Bolts . . . . . .54 N·m (40 ft. lbs.)
Generator B+ Terminal . . . . . . . . .9 N·m (75 in. lbs.)
Starter Mounting Bolts. . . . . . . . .54 N·m (40 ft. lbs.)
Starter Solenoid Battery Nut . . . .10 N·m (90 in. lbs.)
Part Num- Amperage out-
ber put
4727220 86 Amp
4727221 98 Amp
TORQUE
8C - 11