Chrysler 1998 Voyager Service Manual page 459

NS
ADJUSTMENTS (Continued)
To adjust headlamp alignment, rotate adjusting
screws to achieve the specified low beam hot spot
location (Fig. 3).
BUBBLE LEVEL CALIBRATION
(VERTICAL AIM)
After the headlamp alignment has been verified or
set and the bubble level is not centered, calibrate the
bubble level.
NOTE: Any calibration of the headlamp bubble
level must be done on a level surface and the head-
lamp cool. Do not operate the headlamps for a min-
imum of 20 minutes prior to beginning adjustments.
(1) Remove screws holding magnifying window to
top of headlamp module (Fig. 5).
(2) Position magnifying
between headlamp module and radiator closure
panel.
(3) Through slotted hole in magnifying window,
insert small screw driver into bubble level calibration
screw.
Fig. 4 Headlamp Alignment Screen – T&C
window to the side
(4) Rotate calibration screw in proper direction
until bubble is centered on the "O".
(5) Install magnifying window, making sure O-ring
seal is in place.
(6) If necessary, calibrate magnifying window.
MAGNIFYING WINDOW CALIBRATION
(HORIZONTAL AIM)
After the headlamp alignment has been verified or
set and the magnifying window is not centered, cali-
brate the magnifying window.
(1) Loosen screws holding magnifying window to
top of headlamp module (Fig. 5).
(2) Using the calibration knob above headlamp
lens, rotate magnifying window until window is cen-
tered over the "O" on the gauge below the window.
LAMPS 8L - 7