Chrysler 1998 Voyager Service Manual page 66

2 - 34 SUSPENSION
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 81 Installing Ball Joint Seal Boot
LOWER CONTROL ARM FRONT BUSHING
REMOVE
(1) Remove the lower control arm from the front
suspension cradle. Refer to Lower Control Arm in the
Removal And Installation Section in this section of
the service manual for the required procedure.
(2) Securely mount the lower control arm in a vise.
(3) Assemble for removal of the front bushing, the
Bushing Receiver, Special Tool 6908–2, Bushing
Remover, Special Tool 6908–1, Nut, Special Tool
6908–3 thrust washer, threaded rod and small nut,
as shown in (Fig. 82) on the lower control arm and
front bushing.
Fig. 82 Tools Assembled For Removal Of Front
(4) To remove front bushing from lower control
arm, hold the threaded rod stationary and tighten
the Nut, Special Tool 6908–3 (Fig. 82). This will force
the front bushing out of the lower control arm and
into Bushing Receiver, Special Tool 6908–2 (Fig. 82).
Bushing
INSTALL
(1) Securely mount the lower control arm in a vise.
NOTE: The lower control arm front bushing is a
directional bushing. It must be installed in the lower
control arm positioned as shown in (Fig. 83).
(2) Position the front bushing in the lower control
arm so that the 2 rubber blocks on the bushing are
positioned horizontally as shown in (Fig. 83).
Fig. 83 Installation Position Of Lower Control Arm
Front Bushing
(3) Assemble for installation of the front bushing,
the Bushing Receiver, Special Tool 6908–5, Bushing
Installer, Special Tool 6908–4, Nut, Special Tool
6908–3 thrust washer, threaded rod and small nut,
as shown in (Fig. 84) on the lower control arm and
front bushing.
Fig. 84 Tools Assembled For Installation Of Front
(4) To install the front bushing in lower control
arm, hold the threaded rod stationary and tighten
Bushing
NS