Instrument Panel Right End Cover; Junction Block; Knee Blocker Reinforcement - Chrysler 1998 Voyager Service Manual

NS/GS
REMOVAL AND INSTALLATION (Continued)
INSTALLATION
(1) Place instrument panel top cover in position on
vehicle.
(2) Push top cover forward to engage hooks to hold
front of top cover to instrument panel.
(3) Connect wire harness to message center.
(4) Engage clips to hold rear edge of top cover to
instrument panel.
(5) Pull top cover rearward.
(6) Install A-pillar trim.

INSTRUMENT PANEL RIGHT END COVER

REMOVAL
(1) Open passenger side front door (Fig. 37).
Fig. 37 Instrument Panel Right End Cover
(2) Disengage clips holding right end cover to
instrument panel.
(3) Remove instrument panel end cover and foam
pad covering the A/C inlet projection of the end cover
if equipped.
INSTALLATION
For installation, reverse the above procedures.

JUNCTION BLOCK

REMOVAL
(1) Disconnect battery negative cable.
(2) Remove lower steering column cover and knee
blocker reinforcement.
(3) Disconnect four, forty-way connectors from
Junction Block (Fig. 38).
INSTRUMENT PANEL AND SYSTEMS
Fig. 38 Junction Block
(4) Disconnect two wire connectors from bottom of
Body Control Module.
(5) Remove bolts holding Junction Block to dash
panel mounting.
(6) Remove Junction Block from mounting bracket.
(7) Remove screws holding Body Control Module to
Junction Block.
(8) Slide Body Control Module downward to dis-
connect guide studs on Junction Block from BCM
ting bracket.
(9) Separate Junction Block from Body Control
Module.
INSTALLATION
For installation, reverse the above procedures.

KNEE BLOCKER REINFORCEMENT

REMOVAL
(1) Remove lower steering column cover (Fig. 39).
Fig. 39 Knee Blocker Reinforcement
(2) Remove screws holding knee blocker reinforce-
ment to instrument panel.
8E - 25