Chrysler 1998 Voyager Service Manual page 318

8D - 20 IGNITION SYSTEM
REMOVAL AND INSTALLATION (Continued)
Fig. 10 Target Magnet
Fig. 11 Target Magnet Installation
(1) Install target magnet in end of camshaft.
Tighten mounting screw to 5.65 N·m (50 in. lbs.)
torque.
(2) Install a new O-ring on sensor.
(3) Install camshaft position sensor. Tighten sensor
mounting screws to 9.6 N·m (85 in. lbs.) torque.
(4) Attach engine harness connector to camshaft
position sensor.
(5) Install air cleaner inlet tube and filtered air
tube.
MANIFOLD ABSOLUTE PRESSURE (MAP)
SENSOR—2.4/3.3/3.8L
REMOVAL
(1) Disconnect electrical connector from MAP sen-
sor (Fig. 12).
(2) Remove two screws holding sensor to the
intake manifold.
INSTALLATION
(1) Reverse the above procedure for installation.
Fig. 12 Map Absolute Pressure Sensor
THROTTLE POSITION SENSOR
Refer to Group 14, Fuel Injection Section, for
Removal/Installation.
ENGINE COOLANT TEMPERATURE SENSOR—2.4L
The coolant sensor threads into the top of the ther-
mostat housing (Fig. 13). New sensors have sealant
applied to the threads.
Fig. 13 Engine Coolant Temperature Sensor—2.4L
WARNING: HOT, PRESSURIZED COOLANT CAN
CAUSE INJURY BY SCALDING. COOLING SYSTEM
MUST BE PARTIALLY DRAINED BEFORE REMOV-
ING THE COOLANT
REFER TO GROUP 7- COOLING.
TEMPERATURE SENSOR.
NS