Chrysler 1998 Voyager Service Manual page 67

NS
DISASSEMBLY AND ASSEMBLY (Continued)
the Nut, Special Tool 6908–3 (Fig. 84). This will pull
the front bushing into the lower control arm.
(5) Continue pulling the bushing into the lower
control arm until bushing is seated squarely against
the lower control arm and there is no gap between
the bushing and the lower control arm (Fig. 85).
Fig. 85 Correctly Installed Lower Control Arm
(6) Install the lower control arm on the front sus-
pension cradle. Refer to Lower Control Arm in the
Removal And Installation Section in this group of the
service manual for the required procedure.
LOWER CONTROL ARM REAR BUSHING
REMOVE
(1) Remove the lower control arm from the front
suspension cradle. Refer to Lower Control Arm in the
Removal And Installation Section in this group of the
service manual for the required procedure.
(2) Mount the lower control arm in a vise without
using excessive clamping force.
(3) Using a sharp knife, (such as a razor) slit the
bushing lengthwise (Fig. 86) to allow its removal
from the lower control arm (Fig. 86).
(4) Remove the bushing from the lower control
arm.
INSTALL
CAUTION: Do not apply grease or any other type of
lubricant other than the silicone lubricant specified
below to the control arm bushing.
(1) Apply Mopar Silicone Spray Lube or an equiv-
alent, to the hole in lower control arm rear bushing.
This will aid in the installation of the bushing on the
lower control arm.
(2) With the lower control arm held securely in a
vise, install bushing on lower control arm. Install
Bushing
Fig. 86 Slit Lower Control Arm Rear Bushing
bushing by pushing and rocking the bushing until it
is fully installed on lower control arm. Be sure when
bushing is installed it is past the upset on the end of
the lower control arm (Fig. 87).
(3) The rear bushing of the lower control arm,
when correctly installed, is to be positioned on the
lower control arm as shown in (Fig. 87).
Fig. 87 Correctly Installed Lower Control Arm
STABILIZER BAR BUSHING
Disassembly/Assembly
(1) If stabilizer bar to front suspension cradle
bushings require replacement at time of inspection,
install new bushings before installing stabilizer bar.
Stabilizer bar bushings are replaced by opening the
slit on the bushings and peeling them off the stabi-
lizer bar. Install new bushings on stabilizer bar, by
spreading bushing at slit and forcing them on stabi-
lizer bar.
SUSPENSION
Bushing
2 - 35