Chrysler 1998 Voyager Service Manual page 461

NS
REMOVAL AND INSTALLATION
CENTER HIGH MOUNTED STOP LAMP
(CHMSL) BULB . . . . . . . . . . . . . . . . . . . . . . . . 13
FOG LAMP BULB – TOWN and COUNTRY . . . . . 11
FOG LAMP BULB . . . . . . . . . . . . . . . . . . . . . . . . 10
FRONT PARKING AND TURN SIGNAL LAMP
BULB – TOWN and COUNTRY . . . . . . . . . . . . 12
FRONT SIDE MARKER LAMP BULB TOWN and
COUNTRY . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
REMOVAL AND INSTALLATION
HEADLAMP BULB
REMOVAL
(1) Release hood latch and open hood.
(2) From behind radiator closure panel, disconnect
wire connector from back of headlamp bulb base.
(3) Rotate headlamp bulb retaining ring counter-
clockwise.
(4) Remove retaining ring from headlamp (Fig. 1).
(5) Pull headlamp bulb from back of headlamp.
Fig. 1 Headlamp Bulb
INSTALLATION
CAUTION: Do not touch the glass of halogen bulbs
with fingers or other possibly oily surface, reduced
bulb life will result.
(1) From behind radiator closure panel, insert
headlamp bulb into back of headlamp.
(2) Engage retaining ring onto headlamp (Fig. 1).
EXTERIOR LAMP BULB SERVICE
page
INDEX
HEADLAMP BULB – TOWN & COUNTRY . . . . . . . 9
HEADLAMP BULB . . . . . . . . . . . . . . . . . . . . . . . . 9
LICENSE PLATE LAMP BULB . . . . . . . . . . . . . . 13
PARKING AND TURN SIGNAL BULB . . . . . . . . . 11
TAIL, STOP, TURN SIGNAL AND BACK-UP
LAMP BULB . . . . . . . . . . . . . . . . . . . . . . . . . . 12
(3) Rotate headlamp bulb retaining ring clockwise.
(4) Connect wire connector into headlamp bulb
base.
(5) Verify headlamp alignment.
HEADLAMP BULB – TOWN & COUNTRY
HEADLAMP HIGH BEAM
REMOVAL
(1) Release hood latch and open hood.
(2) From behind radiator closure panel, disconnect
wire connector from back of high headlamp bulb
base.
(3) Rotate headlamp bulb counterclockwise and
pull bulb from back of headlamp module (Fig. 2).
INSTALLATION
CAUTION: Do not touch the glass of halogen bulbs
with fingers or other possibly oily surface, reduced
bulb life will result.
(1) Insert bulb into the back of the headlamp mod-
ule.
(2) Rotate headlamp bulb clockwise to engage
bulb.
(3) Connect wire connector to the low beam head-
lamp. Verify headlamp bulb operation
(4) Verify headlamp alignment.
HEADLAMP LOW BEAM
REMOVAL
(1) Release hood latch and open hood.
(2) Remove the three headlamp mounting nuts.
(3) Remove one attaching screw on top of the
crossmember.
(4) Disconnect wire connector from the back of the
low beam headlamp bulb base (Fig. 4).
LAMPS 8L - 9
page