Chrysler 1998 Voyager Service Manual page 450

8K - 10 WINDSHIELD WIPERS AND WASHERS
REMOVAL AND INSTALLATION (Continued)
REAR WINDOW WIPER MOTOR
REMOVAL
(1) Remove rear wiper arm.
(2) Open liftgate.
(3) Remove liftgate trim panel.
(4) Disconnect wire connector from rear wiper
motor.
(5) Remove screws holding rear wiper motor to lift-
gate (Fig. 3).
(6) Remove wiper motor from liftgate.
INSTALLATION
For installation, reverse the above procedure.
Fig. 3 Rear Window Wiper Motor
REAR WIPER ARM
REMOVAL
(1) Lift and hold wiper blade away from rear win-
dow.
(2) Lift lock holding wiper arm to wiper pivot
upward.
(3) Allow wiper arm to rest against lock.
(4) Pull wiper from pivot (Fig. 4).
INSTALLATION
For installation, reverse the above procedure.
Fig. 4 Rear Wiper Arm
REAR WIPER BLADE
REMOVAL
(1) Lift wiper blade away from rear window.
(2) Release latch holding blade to wiper arm (Fig.
5).
(3) Remove blade from wiper arm.
INSTALLATION
For installation, reverse the above procedure.
Fig. 5 Rear Wiper Arm
REAR WIPER BLADE ELEMENT
Refer to Windshield Wiper Blade Element in this
section.
NS