Chrysler 1998 Voyager Service Manual page 475

NS
REMOVAL AND INSTALLATION (Continued)
INSTALLATION
(1) Position bulb to lamp contacts.
(2) Engage bulb to lamp contacts.
(3) Insert long edge of lens into lamp housing.
(4) Press on center of lens to engage remainder of
clips
RAIL LAMP MODULE BULB
REMOVAL
(1) Using a small screw driver, pry stationary end
of rail lamp lens from rail lamp module (Fig. 17).
(2) Remove lens tab from between rail lamp mod-
ule and rail lamp switch.
(3) Remove lens from lamp.
(4) Pull bulb from lamp (Fig. 18).
Fig. 17 Rail Lamp Module Lens
Fig. 18 Rail Lamp Module Bulb
INSTALLATION
(1) Push bulb into bulb contacts in rail lamp mod-
ule.
(2) Insert tab on lamp lens between rail lamp mod-
ule and rail lamp switch.
(3) Snap lens onto lens pivots on module.
LIFTGATE COURTESY LAMP
REMOVAL
(1) Insert trim stick between courtesy lamp and
liftgate trim panel at upper inboard corner of cour-
tesy lamp (Fig. 19).
(2) Disengage tabs holding courtesy lamp to lift-
gate trim panel (Fig. 20).
(3) Disconnect wire connector from courtesy lamp.
(4) Remove lamp from vehicle.
Fig. 19 Courtesy Lamp
Fig. 20 Courtesy Lamp Tabs
INSTALLATION
(1) Position lamp to vehicle.
(2) Connect wire connector to courtesy lamp.
LAMPS 8L - 23