Chrysler 1998 Voyager Service Manual page 412

8F - 10 AUDIO SYSTEMS
REMOVAL AND INSTALLATION (Continued)
QUARTER PANEL SPEAKER
REMOVAL
(1) Remove quarter trim bolster from quarter trim
panel.
(2) Remove screws holding speaker to inner quar-
ter panel (Fig. 17).
Fig. 17 Quarter Panel Speaker
(3) Separate speaker from quarter panel.
(4) Disconnect wire connector from speaker.
(5) Remove speaker.
INSTALLATION
For installation, reverse the above procedure.
D–PILLAR SPEAKER
REMOVAL
(1) Remove D-pillar trim panel as necessary to
gain access to door speaker. Refer to Group 23, Body
for proper procedures.
(2) Disconnect wire connector from speaker.
(3) Remove by sliding speaker out of bracket by
pushing on magnet. The capacitor is wrapped with
foam tape (Fig. 18).
Fig. 18 D–Pillar Speaker
(4) Remove speaker.
INSTALLATION
For installation, reverse the above procedure.
NS