Chrysler 1998 Voyager Service Manual page 494

8L - 16 LAMPS
REMOVAL AND INSTALLATION (Continued)
(6) Separate license plate lamp bar from liftgate
(Fig. 9).
(7) Separate license plate lamp bar grommet from
vehicle.
Fig. 9 License Plate Lamp
INSTALLATION
(1) Route wire connector through hole in liftgate.
(2) Install grommet to wiring harness hole in lift-
gate.
(3) Place license plate lamp bar in position on lift-
gate.
(4) Install screws to hold license plate lamp bar to
liftgate.
(5) Engage wire connector into liftgate wire har-
ness.
(6) Install water shield.
(7) Install liftgate trim panel.
(8) Verify license plate lamp operation.
CENTER HIGH MOUNTED STOP LAMP (CHMSL)
REMOVAL
(1) Release liftgate latch and open liftgate.
(2) Disengage clip holding CHMSL access cover to
liftgate.
(3) Separate cover from liftgate.
(4) Depress plastic tab holding bulb holder to lamp
housing (Fig. 10).
(5) Separate bulb holder from lamp housing.
(6) Remove screws holding CHMSL to liftgate.
(7) Separate CHMSL from vehicle.
Fig. 10 CHMSL Bulb Holder
INSTALLATION
(1) Place CHMSL in position on vehicle.
(2) Install screws to hold CHMSL to liftgate.
(3) Position bulb holder to CHMSL housing.
(4) Snap bulb holder into CHMSL housing.
(5) Place CHMSL access cover in position on lift-
gate.
(6) Engage clip to hold access cover to liftgate.
(7) Verify CHMSL operation.
NS/GS