Chrysler 1998 Voyager Service Manual page 125

NS
REMOVAL AND INSTALLATION (Continued)
Fig. 93 Correctly Supported Caliper
(14) Remove driveshaft from rear drive line mod-
ule and hub/bearing. Driveshaft is removed by first
compressing the inner joint on the driveshaft and
removing it from the drive line module. Then, slide
the outer joint of the driveshaft out of the hub/bear-
ing.
(15) Remove the hub/bearing to axle mounting
bolts (Fig. 94).
Fig. 94 Hub/Bearing Mounting Bolts
CAUTION: Corrosion may occur between the hub/
bearing and the axle. If this occurs the hub/bearing
will be difficult to remove from the axle. If the hub/
bearing will not come out of the axle by pulling on
it by hand, do not pound on the hub/bearing to
remove it from the axle. Pounding on the hub/bear-
ing to remove it from the axle will damage the hub/
bearing. This damage will result in noise or failure
of the hub/bearing. To remove a hub/bearing which
is corroded to the axle, lightly tap the disc brake
caliper adapter using a soft faced hammer. This will
remove both the disc brake caliper adapter and
hub/bearing from the axle. The hub/bearing will
then need to be removed from the caliper adapter.
(16) Remove the hub/bearing from the axle. (Fig.
95).
Fig. 95 Hub/Bearing Removal And Installation
(17) If the disc brake caliper adapter and hub/
bearing were removed as an assembly from the axle
and the hub/bearing cannot be removed from the
adapter by hand, use the following procedure to
remove it from the adapter. With a helper supporting
the caliper adapter in his hands, position Remover,
Special Tool 8214-1 on the cast housing of hub/bear-
ing (Fig. 96). Do not position special tool on
inner race of hub/bearing. Lightly strike Remover,
Special Tool 8214-1 with a hammer to remove the
bearing.
Fig. 96 Hub/Bearing Removal From Caliper Adapter
INSTALL
(1) Install hub/bearing on end of axle. (Fig. 95).
(2) Install the hub/bearing mounting bolts. In a
progressive criss-cross pattern, tighten the 4 hub/
bearing mounting bolts (Fig. 94) until the disc brake
BRAKES 5 - 43