Chrysler 1998 Voyager Service Manual page 469

NS
REMOVAL AND INSTALLATION (Continued)
NOTE: Wire connector may be disconnected at
socket which eliminates removal of liftgate trim.
Fig. 8 License Plate Lamp
INSTALLATION
(1) Place license plate lamp bar in position on lift-
gate.
(2) Install screws to hold license plate lamp bar to
liftgate.
(3) Connect wire connector into liftgate wire har-
ness.
(4) Install water shield.
(5) Install liftgate trim panel.
(6) Verify license plate lamp operation.
CENTER HIGH MOUNTED STOP LAMP (CHMSL)
REMOVAL
(1) Release liftgate latch and open liftgate.
(2) Disengage clips holding CHMSL access cover to
liftgate.
(3) Remove cover from liftgate.
(4) Rotate bulb sockets counterclockwise one quar-
ter turn.
(5) Pull sockets from lamp.
(6) Remove screws holding CHMSL to liftgate.
(7) Remove CHMSL from vehicle (Fig. 9).
Fig. 9 CHMSL
INSTALLATION
(1) Place CHMSL in position on vehicle.
(2) Install screws to hold CHMSL to liftgate.
(3) Insert bulb into socket.
(4) Insert sockets into lamp.
(5) Rotate bulb sockets clockwise one quarter turn.
(6) Place CHMSL access cover in position on lift-
gate.
(7) Engage clips to hold access cover to liftgate.
(8) Verify CHMSL operation.
LAMPS 8L - 17