Chrysler 1998 Voyager Service Manual page 523

NS/GS
REMOVAL AND INSTALLATION (Continued)
Fig. 3 Smart Key Immobilizer Module Remove/Install
(7) Unplug the wire harness connector from the
SKIM receptacle.
VEHICLE THEFT/SECURITY SYSTEMS
(8) Remove the screw securing the SKIM module
to the steering column.
(9) Release the clip holding the SKIM antenna to
the ignition lock housing on the steering column.
(10) Remove the SKIM from the vehicle.
(11) Reverse the removal procedures to install.
Tighten the non-tilt steering column mounting nuts
to 22 N·m (200 in. lbs.) and the steering column
shroud mounting screws to 2 N·m (18 in. lbs.).
(12) If the SKIM is replaced with a new unit, a
DRB scan tool and the proper Diagnostic Procedures
manual MUST be used to initialize the new SKIM
and to program at least two Smart Key transponders.
8Q - 5