Chrysler 1998 Voyager Service Manual page 488

8L - 10 LAMPS
REMOVAL AND INSTALLATION (Continued)
INSTALLATION
CAUTION: Do not touch the glass of halogen bulbs
with fingers or other oily surfaces, reduced bulb life
will result.
(1) Engage wire connector into fog lamp wire har-
ness.
(2) Insert bulb into lamp so index notches on bulb
engage with bosses in lamp (Fig. 7).
(3) Hinge wire retainer clip over bulb base.
(4) Engage wire clip to hold bulb into lamp.
(5) Install rear cover on fog lamp.
(6) Install fog lamp on vehicle.
SIDE REPEATER LAMP BULB
REMOVAL
(1) Push side repeater lamp to one side and
release retaining tab (Fig. 8).
Fig. 8 Side Repeater Lamp
(2) Pull side repeater lamp out and disengage bulb
socket from lamp (Fig. 9).
Fig. 9 Side Repeater Lamp Bulb
(3) Rotate and pull bulb from socket.
INSTALLATION
(1) Push and twist bulb into socket.
(2) Push side repeater lamp socket into side
repeater lamp.
(3) Position side repeater lamp to hole in fender.
(4) Push side repeater lamp to one side and seat
retaining tab into fender.
(5) Verify lamp operation.
TAIL LAMP BULB
The tail lamp houses the tail/stop lamp, rear turn
signal lamp, back-up lamp, and rear fog lamp bulbs.
NS/GS