Chrysler 1998 Voyager Service Manual page 335

NS
REMOVAL AND INSTALLATION (Continued)
Fig. 7 Ignition Switch Mounting Screw
Fig. 8 Ignition Switch Retaining Tab
Fig. 9 Removing Ignition Switch
INSTALLATION
(1) Ensure the ignition switch is in the RUN posi-
tion and the actuator shaft in the lock housing is in
the RUN position.
Fig. 10 Ignition Switch Connectors
(2) Install electrical connectors to ignition switch.
(3) Carefully install the ignition switch. The
switch will snap over the retaining tabs (Fig. 11).
Install mounting screw (Fig. 7).
(4) Install upper and lower shrouds.
(5) Install key cylinder (cylinder retaining tab will
depress only in the RUN position).
(6) Connect negative cable to battery.
Fig. 11 Ignition Switch Installation
(7) Check for proper operation of ignition switch
and key-in warning switch.
IGNITION SYSTEM 8D - 37