Instrument Cluster Lamps; Instrument Cluster Lens - Chrysler 1998 Voyager Service Manual

8E - 22 INSTRUMENT PANEL AND SYSTEMS
REMOVAL AND INSTALLATION (Continued)
(5) Remove screws holding cluster bezel to instru-
ment panel from each side of steering column.
(6) Disconnect clip holding cluster bezel to instru-
ment panel from above right vent louver.
(7) Separate cluster bezel from instrument panel.
(8) Disconnect wire connectors from back of the
bezel.
INSTALLATION
(1) Connect wire connectors into back of the bezel.
(2) Place cluster bezel in position on instrument
panel. Use care not to place hands on louvers.
(3) Connect clips to hold cluster bezel to instru-
ment panel. Use care not to add pressure on the A/C
louvers to seat the cluster bezel clips.
(4) Install screws to hold cluster bezel to instru-
ment panel on each side of steering column.
(5) Install screw at left end of cluster bezel and
headlamp switch.
(6) Install left end cover.
(7) Install over steering column bezel.
(8) Install lower steering column cover.

INSTRUMENT CLUSTER LAMPS

REMOVAL
(1) Remove the instrument cluster. Refer to Instru-
ment Cluster Removal procedure.
(2) Locate the lamp (Fig. 18).
(3) Remove the lamps from cluster with a 1/4 turn
twist.
Fig. 18 Cluster Lamp Location
INSTALLATION
For installation, reverse the procedures.

INSTRUMENT CLUSTER LENS

REMOVAL
(1) Remove the instrument cluster.
(2) Remove the screws holding the lens to the
instrument cluster (Fig. 19).
(3) Remove the lens from cluster.
INSTALLATION
For installation, reverse the procedures.
Fig. 19 Instrument Cluster Lens
NS