Chrysler 1998 Voyager Service Manual page 462

8L - 10 LAMPS
REMOVAL AND INSTALLATION (Continued)
Fig. 2 Headlamp High Beam Bulb – T&C
(5) Rotate headlamp bulb retainer counterclock-
wise and disengage retainer from headlamp (Fig. 3).
(6) Pull headlamp bulb from back of the headlamp
module.
INSTALLATION
CAUTION: Do not touch the glass of halogen bulbs
with fingers or other possibly oily surface, reduced
bulb life will result.
(1) Place headlamp bulb into headlamp module.
(2) Rotate headlamp bulb retainer clockwise to
engage retainer.
(3) Connect wire connector to the low beam head-
lamp. Verify headlamp bulb operation
(4) Install the headlamp module.
(5) Verify headlamp alignment.
Fig. 3 Low Beam Headlamp Retainer
Fig. 4 Headlamp Low Beam Bulb – T&C
FOG LAMP BULB
REMOVAL
(1) Remove fog lamp from vehicle.
(2) Remove rear cover from fog lamp.
(3) Disengage wire clip holding bulb in fog lamp
(Fig. 5).
(4) Hinge wire retainer clip out of bulb removal
path.
(5) Pull bulb from lamp.
(6) Disconnect wire connector from fog lamp wire
harness.
Fig. 5 Fog Lamp Bulb
INSTALLATION
CAUTION: Do not touch the glass of halogen bulbs
with fingers or other oily surfaces, reduced bulb life
will result.
NS