Chrysler 1998 Voyager Service Manual page 152

5 - 70 BRAKES
DISASSEMBLY AND ASSEMBLY (Continued)
(7) Road test vehicle to ensure proper operation of
the vehicle's power brake system.
MASTER CYLINDER FLUID RESERVOIR
(1) Clean master cylinder housing and brake fluid
reservoir. Use only a solvent such as Mopar Brake
Parts Cleaner or an equivalent.
(2) Remove the filler tube and brake fluid reser-
voir cap. Using a syringe or equivalent type tool
empty as much brake fluid as possible from the res-
ervoir.
CAUTION: When removing fluid reservoir from the
master cylinder, do not pry off using any type of
tool. This can damage the fluid reservoir or master
cylinder housing.
(3) Remove the master cylinder assembly from the
power brake vacuum booster. Refer to master cylin-
der, in the removal and installation section in this
group of the service manual for the required proce-
dure
(4) Mount the master cylinder in a vise using the
master cylinder mounting flange (Fig. 174).
Fig. 174 Master Cylinder Correctly Mounted In Vise
(5) Using correct size pin punch, remove the 2
retaining pins between the fluid reservoir and master
cylinder housing (Fig. 175). Rock the brake fluid res-
ervoir from side to side while pulling up to remove it
from the seal grommets in master cylinder housing.
(6) Remove the 2 master cylinder housing to brake
fluid reservoir seal grommets (Fig. 176).
(7) Install new master cylinder housing to brake
fluid reservoir sealing grommets (Fig. 176) in master
cylinder housing.
(8) Lubricate reservoir mounting area with fresh
clean brake fluid. Place reservoir in position over
sealing grommets. Seat reservoir into sealing grom-
mets using a rocking motion while firmly pressing
down on fluid reservoir.
Fig. 175 Fluid Reservoir Retaining Pins
Fig. 176 Master Cylinder To Fluid Reservoir Seal
Grommets
(9) Be sure fluid reservoir is positioned properly on
master cylinder. Bottom of fluid reservoir is to be
touching the top of both sealing grommets
when properly installed on master cylinder
housing.
(10) Install the 2 fluid reservoir to master cylinder
retaining pins (Fig. 175).
(11) Install the master cylinder assembly on the
power brake vacuum booster. Refer to master cylin-
der, in the removal and installation section in this
group of the service manual for the required proce-
dure
(12) Install filler tube on the fluid reservoir. Fill
fluid reservoir to its proper level as indicated on the
outboard side of the fluid reservoir. Be careful not
to over fill the fluid reservoir, fluid is not
intended to be stored in the filler tube. Install
cap on fluid reservoir filler tube.
NS