Chrysler 1998 Voyager Service Manual page 483

NS/GS
SERVICE PROCEDURES
HEADLAMP ALIGNMENT PREPARATION . . . . . . 5
SERVICE PROCEDURES
HEADLAMP ALIGNMENT PREPARATION
(1) Verify headlamp dimmer switch and high beam
indicator operation.
(2) Verify that the headlamp leveling switch is in
the "0" position.
(3) Inspect and correct damaged or defective com-
ponents that could interfere with proper headlamp
alignment.
(4) Verify proper tire inflation.
(5) Clean headlamp lenses.
(6) Verify that luggage area is loaded as the vehi-
cle is routinely used.
(7) Fuel tank should be FULL. Add 2.94 kg (6.5
lbs.) of weight over the fuel tank for each estimated
gallon of missing fuel.
HEADLAMP ALIGNMENT
INDEX
page
ADJUSTMENTS
ADJUSTMENTS
HEADLAMP/FOG LAMP ADJUSTMENT USING
ALIGNMENT SCREEN
ALIGNMENT SCREEN PREPARATION
lar to a flat wall 10 meters (32.8 ft.) away from front
of headlamp lens (Fig. 1).
ride height of the vehicle when driven.
(32.8 ft) away from and parallel to the wall.
on the wall at the centerline of the vehicle. Sight
along the centerline of the vehicle (from rear of vehi-
cle forward) to verify accuracy of the line placement.
HEADLAMP/FOG LAMP ADJUSTMENT USING
ALIGNMENT SCREEN
(1) Position vehicle on a level surface perpendicu-
(2) Place 75 kg in the driver's seat to simulate the
(3) If necessary, tape a line on the floor 10 meters
(4) From the floor up 1.27 meters (5 ft), tape a line
LAMPS 8L - 5
page
. . . . . . . . . . . . . . . . . . 5