Chrysler 1998 Voyager Service Manual page 312

8D - 14 IGNITION SYSTEM
SERVICE PROCEDURES (Continued)
Fig. 30 Setting Spark Plug Electrode Gap—Typical
Fig. 31 Power Distribution Center Retaining Screws
(7) Pull PDC rearward to remove from front
bracket. Lay PDC aside to allow access to Powertrain
Control Module (PCM).
(8) Squeeze tabs on 40-way connector. Pull connec-
tor rearward to remove from PCM (Fig. 35). Remove
both way connectors.
(9) Remove 3 screws holding PCM to fender (Fig.
36).
(10) Remove PCM from vehicle.
Fig. 32 Battery Heat Shield
Fig. 33 Battery Clamp
INSTALLATION
(1) Connect 2 40-Way electrical connectors to PCM
(Fig. 35).
(2) Install PCM. Tighten mounting screws.
(3) Install PDC bracket.
(4) Install battery.
NS