Chrysler 1998 Voyager Service Manual page 147

NS
REMOVAL AND INSTALLATION (Continued)
(30) Road test the vehicle and make several stops
to wear off any foreign material on the brakes and to
seat the brake shoe linings.
FRONT PARK BRAKE CABLE
REMOVE
(1) Raise vehicle on jackstands or centered on a
hoist. See Hoisting in the Lubrication and Mainte-
nance group of this service manual.
(2) Manually lockout the automatic self adjusting
mechanism of the park brake pedal assembly. Refer
to Manual Lockout Of Auto Adjuster Mechanism in
this section of the service manual for the required
procedure.
(3) Remove the intermediate and left rear park
brake cable from the park brake cable equalizer (Fig.
159).
Fig. 159 Park Brake Cable Attachment To Equalizer
(4) Remove the front park cable housing retainer
from body outrigger bracket (Fig. 160). Cable is
removable by sliding a 14 mm box wrench over cable
retainer and compressing the three retaining fingers.
Alternate method is to use an aircraft type hose
clamp and screwdriver.
(5) Lower vehicle.
(6) Remove the left front door sill molding.
(7) Remove the left front kick panel for access to
the park brake cable and park brake pedal assembly.
(8) Lift floor mat for access to park brake cable
and floor pan. Pull the seal and the park brake cable
(Fig. 161) out of the floor pan of vehicle.
(9) Pull park brake cable strand end forward and
disconnect button from clevis. Tap cable housing end
fitting out of pedal assembly bracket.
(10) Remove cable retainer from the park brake
pedal assembly bracket.
(11) Pull park brake cable assembly out of vehicle
through hole in floor pan.
Fig. 160 Front Park Brake Cable Attachment To
Fig. 161 Front Park Brake Cable At Floor Pan
INSTALL
(1) Pass park brake cable assembly through hole
in floor pan from the inside of the vehicle.
(2) Pass cable strand button through the hole in
the pedal assembly bracket.
(3) Install cable retainer onto the park brake cable
and then install cable retainer into pedal assembly
bracket.
(4) Install the end of the park brake cable into the
retainer previously installed into the park brake
pedal bracket.
(5) Install cable strand button into the clevis on
the park brake pedal mechanism.
(6) Install the front park brake cable floor pan seal
into hole in floor pan. Seal is to be installed so the
flange on the seal is flush with the floor pan (Fig.
161). Fold carpeting back down on floor.
(7) Raise vehicle.
(8) Insert brake cable and housing into body out-
rigger bracket making certain that housing retainer
fingers lock the housing firmly into place (Fig. 160).
BRAKES
Body
5 - 65