Chrysler 1998 Voyager Service Manual page 489

NS/GS
REMOVAL AND INSTALLATION (Continued)
REMOVAL
(1) Release liftgate latch and open liftgate.
(2) Remove screws holding tail lamp to rear door
opening trough (Fig. 10).
(3) Separate inner end of lamp from quarter panel.
(4) Disengage hook holding outer end of lamp to
quarter panel opening.
(5) Separate lamp from quarter panel.
(6) Remove screws holding bulb holder to lamp
housing (Fig. 11).
(7) Separate bulb holder from lamp housing.
(8) Retrieve the rubber washers that seal the bulb
holder to the lamp housing at the bulb holder screw
locations.
(9) Pull bulb from bulb holder socket (Fig. 12).
Fig. 10 Tail Lamp
INSTALLATION
(1) Align key on bulb base to groove in bulb holder
socket and insert bulb into socket (Fig. 12).
(2) Position bulb holder to lamp housing.
(3) Verify that the rubber washers are properly
positioned between the bulb holder and lamp housing
at the screw locations.
(4) Install screws to hold bulb holder to lamp hous-
ing.
(5) Position lamp to quarter panel.
(6) Engage hook to hold outer end of lamp to quar-
ter panel opening.
(7) Install screws to hold lamp to rear door open-
ing trough.
(8) Verify tail lamp operation.
Fig. 11 Tail Lamp Bulb Holder
Fig. 12 Pull Bulb From Bulb Holder
LAMPS 8L - 11