Telephone Number 3 - GE NX-10 Installer Manual

91
NX-10 Installers manual

Telephone number 3

LOCATION 12 - PROGRAMMING PHONE N° 3 (20 segments, numerical data)
Phone N°3 is programmed in location 12. A "14" indicates the end of the phone number. Delays of
four seconds can be programmed at any point in the phone number by programming a "13" in the
appropriate segment. The system will always wait for a dial tone unless the first digit of the phone
number is a "13"; in this case, it will only delay. Tone (DTMF) dialling is default. If you want pulse
tone dialling, program a "15" in the segment where pulse dialling should begin. If the entire number
should be pulse dialling, program a "15" in the first segment. Program an "11" for a "*", and a "12"
for a "#".
Note: A zero is programmed as a "0".
LOCATION 13 - ACCOUNT CODE FOR PHONE N° 3 (6 segments, numerical data)
Use location 13 to program the account code that is sent when phone N°3 is dialled. A zero in the
account code is programmed as a "0". A "10" indicates the end of the account code, so program a
"10" in the segment immediately after the last digit of the account code. If the account code is 6
digits long, program all 6 segments. If location 6 is left un-programmed, account code 1 will be used
when phone N°3 is dialled.
LOCATION 14 - COMMUNICATOR FORMAT FOR PHONE N° 3 (1 segment, numerical data)
Location 14 contains the communicator format used to transmit to the receiver that is connected to
phone N°3. Consult the instruction manual for your central station receiver in order to determine
which format is compatible. See Appendix 3 for all available format selections. If you require a
format other than those listed, review the override options described in location 18 to create the
appropriate format. In order to create a special format, a "15" must be programmed in location 14, in
addition to the entries in location 18. If this location contains a "0", format 1 will be used when
phone N°3 is dialled.
LOCATION 15 - DIAL ATTEMPTS/BACKUP CONTROL FOR PHONE N° 3 (2 segments, numerical
data)
Segment 1, dial attempts: Segment 1 of location 15 is used to enter the number of dial attempts (1
to 15) that the communicator will make to phone N°3 before it ends the notification process. Factory
default is "0", and the communicator will make the same number of attempts as those programmed in
location 3.
There will be a waiting time of 12 seconds between the first two dial attempts, and a waiting time of
60 seconds between each subsequent dial attempt (regardless of the number dialled).
Segment 2 - Phone N° 3 backup control: Programming a "0" in segment 2 of this location will
cause the NX-10 to make the designated number of attempts to phone N°2 before setting the "Fail To
Communicate" condition and stop reporting. Programming a "1" in this segment will cause the NX-