Connecting The Nx-586E To A Pc And A Panel - GE NX-10 Installer Manual

Table 34. NX-586E direct connect module serial connector
Sub
RXD
TXD
GND
Connect the cable to the NX-586E direct connect module.
7.
Using stripped wires, connect the cable with alligator clips to a NX-10 panel as follows:
8.
•
Red to POS
•
Black to COM
•
Green to DATA

Connecting the NX-586E to a PC and a panel

Connect the NX-586E direct connect module to the serial port of the PC and the panel as shown in
the previous section.
Figure 28. Connecting the NX-586E to a PC and a panel
!
"
DATA
POS
COM
NX-10
D9
PIN 2
PIN 3
PIN 5
NX-586
D25
PIN 3
PIN 2
PIN 7
#