GE NX-10 Installer Manual page 209

Term Definition
Network An Options menu entry that groups network options.
Non transparent An operating mode for CSD on a GSM network. An intermediate modem is used on the network to
mode transfer data from one modem to another.
O
Only Registered An Options menu setting that allows commands to be accepted only from registered HomeText
Phones phone numbers.
Opening/Closing A Reporting setting that sends a report to the selected report control stating when the system is
opened (disarmed) and closed (armed).
Operator Selection An Options setting that configures the GSM network operator used by the NX-7002. Set this to 00000
to allow the SIM card automatically select a network operator. Alternatively, enter an operator ID
code to manually select a network operator.
The Logged into GSM Network message does not appear if an invalid selection is made or the
network is unreachable.
Options A menu entry that groups the NX-7002 options.
P
Partition Account A Reporting menu entry that lists the account codes for each partition. The account code is sent
Codes when the relevant partition is reported. There are two sets of account codes. The first set assigns an
account code to each report destination. The second set assigns an account code to each partition.
If you attempt to use both sets, the partition account code takes precedence.
See also Account Code
Password An Options setting that configures the password for a PAP login. Contact the network provider to
confirm if a PAP login is required and to obtain the user ID and password.
Password Always An Options menu setting that requires a password to be included when a HomeText message is sent
Required to the system. Passwords must be between 6 and 16 characters and contain at least one number
between
0-9. They should only have alphanumeric characters and no spaces.
Phone Number A Reporting setting that sets the phone number to which SMS reports are sent.
An Up/download setting that sets the phone number of the PC running the upload/download
software.
Polling Time A Reporting setting that configures the length of theTCP/IP polling time.
This value must match the TCP/IP polling time set on a TCP/IP receiver. The value chosen is
determined by the level of security required and the cost of data transmission. This can be from 1 to
255 minutes on the NX-7002 and 1 to 255 seconds on the NX-590. If set to 0, the option is disabled.
Polling Units A Reporting setting that sets polling time in either hours or minutes.
Port Numbers An Options menu entry that groups TCP/IP port options.
Power A Options menu entry that groups power related status messages.
Power A Reporting menu entry that groups the power events that are reported to the selected report
control.
Power Trouble and A Reporting setting that reports mains failure, mains restore, low battery and low battery restore
Restores events to the selected report control.
Primary reporting The main means of reporting selected events.
See also Secondary reporting
Program/Download A Reporting setting that reports programming and up/download events to the selected report
control.
A Reporting setting that configures the communicator format used to report to the selected SMS
Protocol
receiver. Consult the instructions for your central station receiver to determine which format is
NX-10 Installers manual
209