GE NX-10 Installer Manual page 173

Term
Internal Reed
Jam Detection
Keyfob
Keyfob Disarming
Keyfob Funct 1
Keyfob Funct 2
Keyfob User ID
Learn RF Keypad
Learn RF Sir/IO
Learn RF Zone
Learn-RF Device
Log Event
Model
Normal Window
Option 1
Option 2
Definition
A menu option on an RF door/window sensor that enables the internal reed
contact.
A menu option that enables the detection of RF jamming.
A menu entry that groups options relating to any device that sends commands
by a wireless receiver.
When this option is set to Normal (loc 193 bit 6) user can arm and disarm using
keyfob buttons.
When this option is set to Restricted user can arm, but can disarm only during
entry time or when partition is part-armed.
A menu option that enables the light bulb button on the keyfob for the selected
RF zone on the selected RF receiver. If this option is enabled, pressing the light
bulb button sends a keyfob function 1 event. Control panel auxiliary outputs
and NX-507E/NX-508E outputs can be programmed to respond to this event. If
this option is disabled, pressing the light bulb button starts the Arm Away
mode.
Note: It is an equivalent of Option 1 (above) and it can be set in either place.
A menu option that enables the * button on the keyfob for the selected RF zone
on the selected RF receiver. If this option is enabled, pressing the * button
sends a keyfob function 2 event. Control panel auxiliary outputs and NX-
507E/NX-508E outputs can be programmed to respond to this event. If this
option is disabled, pressing the * button starts the Arm Stay mode.
Note: It is an equivalent of Option 2 (above) and it can be set in either place.
A menu option that makes the keyfob report as the zone that it is learned into.
When this option is disabled, all keyfobs report their open/closing reports as
user 99.
A menu command that triggers the learn-in mode for the RF keypad.
A menu command that triggers the learn-in mode for the siren or IO module.
A menu command that triggers the learn-in mode for the RF zone (sensor).
A menu option that enables the mode in which a new wireless device is
enrolled on the system.
A menu option that specifies whether the output switching on and off is
logged.
A menu option that displays the model of the selected receiver.
A menu option that specifies the normal supervision window for RF devices. RF
devices on 868 MHz typically report every 15 minutes. Depending on the
country regulations, this timer must be set to specific values.
A menu option used for configuring a sensor. For actual setting description, see
the particular sensor manual. For example, in case of a keyfob it enables the
keyfob function 1 (see below).
A menu option used for configuring a sensor. For actual setting description, see
the particular sensor manual. For example, in case of a keyfob it enables the
NX-10 Installers manual
173