Appendix 5: Tasks Summary - GE NX-10 Installer Manual

Appendix 5: Tasks summary

Users with different rights are allowed to perform different tasks in the system. Table 45 System tasks
lists each task. Black fields indicate tasks that cannot be performed at the particular level, while white
fields indicate allowed actions. Checkmarks denote tasks that can be performed conditionally, and
conditions required are explained in the Condition column.
Table 45. System tasks
Task
Adjusting the LCD contrast
Answer an up/download
call
Arm and disarm the
system
Bypass a zone
Configure home
automation devices
Control home automation
devices
Engineer tamper reset
Initiate an up/download
call
Perform a configured test
Perform a service check
Perform a walktest
Program voice phone
numbers
Reset fire detector
Set system date and time
Set user authority level
Set user codes
Switch between master
mode and single-partition
mode
View the alarm memory
View the event log
Installer Master user
*
*
*
*
*
User No code
*
* **
* *
*
*
NX-10 Installers manual
Condition
* If the 2.4.2.7 Require Code for
Download menu option is set to No.
* If authority allows (see settings in
the Authority menu group).
** If the keypad is in a single-
partition mode, and the 2.5.2.1.1
Quick Arm menu option is set to Yes,
you can arm without entering the
user code, just by pressing the F3, F4
or F7 function key.
* If authority allows (see settings in
the Authority menu group).
* If enabled for master users., i.e. if
the 2.6.2.4.2 Master Code Resets
Tamper Memory menu option is set
to Yes.
* If enabled for use without a code,
i.e. if the 2.4.2.7 Require Code for
Download menu option is set to No.
* If the 3.1.6 User Phone Editing
menu option is set to Enabled.
* Only own code, Duress Code and
GuardCodes 16 17.
253