GE NX-10 Installer Manual page 169

IO modules can be also triggered by keyfob buttons. This way you can turn on and off some external
device or activate a wireless siren. To do this you must activate the switch output functionality for the
keyfob, and correctly set the event triggering the selected output on the particular IO module. The
following example configures the button 1 on the keyfob (light bulb button), to allow it to toggle the
output 1 on the I/O module 4 ON and OFF.
Note: Output cannot be latched when this functionality is enabled (i.e. RF Receiver 32>Outputs>I/O 4 Output
1>Attributes>Output Latched MUST be set to NO), otherwise after triggering output with the keyfob you will
not be able to switch it off with the keyfob.
Navigate with the
1.
Scroll to the correct Sensor n (where the keyfob is already programmed) and then select
2.
Keyfob>Keyfob Funct 1 and press OK.
Scroll to Switch Output 1 and press OK. The keypad beeps once to accept the change and
3.
returns to Keyfob Funct 1.
Navigate with the
4.
Scroll to I/O 4 Output 1 and press OK.
5.
Select Event>Keyfob Funct 1 and press OK.
6.
The keypad beeps once to accept the change and returns to Event.
7.
Navigate with the
8.
The keypad beeps once to accept the change and returns to Time.
9.
Navigate with the
10.
1 only and press OK.
The keypad beeps once to accept the change and returns to Partitions.
11.
Navigate with the
12.
Select No and press OK.
The keypad beeps once to accept the change and returns to Output Latched. The Code
13.
Stops Timer option is ignored in this case, so it does not have to be set.
After the siren/IO module is learned-in you need to set up threshold values and turn the
antipassivation feature ON, if necessary. The following example sets the threshold low battery value
to 30 x 0.1 V, threshold low auxillary voltage to 98 x 0.1 V and turns the antipassivation feature ON
for the RF siren/IO module 1.
Navigate with the
1.
press OK.
Scroll to RF Siren/IO 1 and press OK.
2.
Scroll to Threshold and press OK.
3.
Scroll to Low Battery and press OK. Set the low battery threshold to 30 x 0.1 V with the
4.
keys and press OK. The keypad beeps once to accept the change and returns to Low
Battery.
Scroll to Low Aux Voltage and press OK. Set the low auxillary voltage threshold to
5.
98 x 0.1 V with the
and returns to Low Aux Voltage.
Navigate with the
6.
press OK.
keys to RF Receivers>RF Receiver 32>Inputs and press OK.
keys to RF Receivers>RF Receiver 32>Outputs and press OK.
keys to I/O 4 Output 1>Time, enter 0 and press OK.
keys to I/O 4 Output 1>Partitions and press OK. Select partition
keys to I/O 4 Output 1>Attributes>Output Latched and press OK.
keys to RF Receivers>RF Receiver 32>Sirens/IO Features and
keys and press OK. The keypad beeps once to accept the change
keys to Sirens/IO Features>RF Siren/IO 1>Antipassivation and
NX-10 Installers manual
169