Programming Partition Parameters - GE NX-10 Installer Manual

LOCATION 84 - BUS FAULT AND BUS FAULT RESTORE COMMUNICATOR CODES, SLOW SPEED
FORMATS ONLY (4 segments, numerical data)
Location 84 contains the tens and ones digits for a 4+2 and 3+1 format that will be sent if "Short
circuits and ground faults" reporting is enabled. Segment 1 contains the tens digit of the "Bus Fault
Reporting". Segment 2 contains the ones digit of the "Bus Fault Reporting". Segment 3 contains the
tens digit of the "Bus Fault Restore". Segment 4 contains the ones digit of the "Bus Fault Restore".
For a 3+1 format, only the segment 1 digit resp. segment 3 digit (tens) will be sent.
LOCATIONS 85-87 - RESERVED

Programming partition parameters

Locations 88-109 are for programming different account codes and/or features for each partition. If a
location is left unprogrammed, the feature for partition 1 and the account code for the phone number
will be used.
LOCATION 88 - ACCOUNT CODE FOR PARTITION 1 (6 segments, numerical data)
Location 88 contains the account code that is sent when partition 1 is reported. If location 88 is left
unprogrammed (all "10"s), then the account code corresponding to the phone number that is dialled
will be used. If the account code is less than six digits, program a "10" in the segment immediately
after the last digit of the account code. If the account code is 6 digits long, program all 6 segments.
LOCATION 89 - ACCOUNT CODE FOR PARTITION 2 (6 segments, numerical data)
Location 89 contains the account code that is sent when partition 2 is reported. If location 89 is left
unprogrammed (all "10"s), then the account code corresponding to the phone number that is dialled
will be used. If the account code is less than six digits, program a "10" in the segment immediately
after the last digit of the account code. If the account code is 6 digits long, program all 6 segments.
LOCATION 90 - PARTITION 2 FEATURE AND REPORTING SELECTIONS (5 segments, feature
selection data)
Location 90 is used to enable certain features that the user can access or see from the keypad of the
system. In addition, certain communicator reports are enabled in this location. Each of these features
can be enabled by partition. This location contains 5 segments, with eight possible features per
segment. Refer to location 23 for the feature selections. If all the segments are blank (nothing
enabled), the features for partition 1 will be used.