GE NX-10 Installer Manual page 15

Part number Description
NX-1701E Door swipe
module
NX-320-I Auxiliary power
module
NX-507E/NX- Output expander
508E module
NX-534E Audio (listen-in)
module
NX-535 Voice module
NX-586E Direct connect
module
NX-590E TCP/IP Module
NX-7002 GPRS module
NX-10 Installers manual
Purpose
Proximity card reader/door control module. You can program it
to control access in any or all partitions.
Provides additional power for modules attached to a panel.
Expands the number of outputs available on the system.
Two-way audio (listen-in) communicator that allows the
situation on the premises to be monitored.
Allows events to be reported using voice messages.
Used as:
1. A direct connect interface between the panel and PC.
2. A storage device, when connected only to the PC. You can
also read/write from 1 of the 4 locations via the DL900
downloader.
3. A storage device, connected only to the panel. You can
read/write from 1 of the 4 locations on the NX-10.
Dual microprocessor-controlled Internet/Intranet interface.
Allows events to be reported via a GSM network or a GPRS
network. The GPRS module is a part of the main panel board,
so it does not require a separate installation procedure. It is
available on the NX-10-GSM-EUR and NX-10-GSM-LB-EUR
panels only (not on the NX-10-EUR and NX-10-LB-EUR panels.)
15