Table of Contents
Advertisement
How You
Communicate
to Your System
Note
The Master Access Code
default is 1-2-3-4 when the
security system is shipped
from the factory. You should
change your code after your
system is installed (see
"Programming Your Sys-
tem").
2
Outdoor Motion Sensors detect motion in a protected outdoor area. When motion is
detected, the system may respond by sounding chimes or turning on outside lights.
These sensors are not used for intrusion detection.
Door/Window Sensors detect the opening of a door or window.
Smoke Sensors detect smoke and a significant rise in temperature. They have a built in
siren that sounds when smoke or a significant rise in temperature is detected.
Freeze Sensors detect furnace failure. If the inside temperature drops below 41
sensor will notify the panel. The sensor will send a restore signal to the panel when the
°
temperature rises to 50
F.
Carbon Monoxide Sensors detect carbon monoxide. They have a built in siren that
sounds when carbon monoxide is detected.
Modules
* Appliance Modules can be programmed to turn appliances or fluorescent lights on
and off.
* Lamp Modules can be programmed to turn non-fluorescent lights on and off.
* Universal Modules are primarily used for controlling devices other than appliances
and lamps. Check with your installer for other applications.
Audio Verification Module (AVM) is primarily used by the central monitoring station
to monitor sounds and verbally communicate with a person inside the home. This fea-
ture is similar to a speaker phone feature on a phone.
* Dialog RF Electronic Thermostat is primarily used to monitor and control HVAC
systems from the security system.
* Not investigated for use by UL
Sending commands or instructing your security system is done through key presses on
the panel, touchpads, or through the use of a remote telephone.
Control Panel
You can enter commands for your security system through simple key presses on the
panel. Depending on how your system is programmed, you may need to enter an access
code for certain commands. An access code is a numeric code that allows authorization
to operate your security system.
Remote Handheld Touchpad
This touchpad gives you the option to enter commands from any room in your house.
You can enter commands through simple key presses on the touchpad.
Dialog Touchtalk 2-Way RF Touchpad
This touchpad gives you the option to enter commands from a remote location (away
from the control panel) in your house. It also allows you to hear panel messages when
the System Status button is pressed.
Keychain Touchpad
Keychain Touchpads are handy for simple arming, disarming and light control func-
tions. They are portable and can be carried off-site in a purse or pocket
Telephone
Touchtone telephones can be used to communicate with your system while you are off-
site. Ask your installer if you have this feature.
°
F, the
Security Pro 1000
Advertisement
Table of Contents
