Using The Gsm/Gprs Module; Obtaining The Gsm/Gprs Module Status - GE NX-10 Installer Manual

Report type

Using the GSM/GPRS module

This section provides information on using the GSM/GPRS GPRS module.

Obtaining the GSM/GPRS module status

System status information is GSM/GPRS specific.
Enter programming mode.
1.
Navigate with the keys to NX-7002 Module>Options>Status Check and press OK.
2.
Scroll through the status messages to view the current status of the module. Table 22,
3.
Status messages explains each status message.
Table 22. Status messages
Message
GSM Connection GSM Engine Comms
SIM PIN Accepted
Logged into GSM Network
SIM PUK Required
Sending SMS
Using GSM Audio
Using GSM CSD
GPRS Connected
Good RSSI
Power Battery Fault
SM PSU Fault
Information Menu Option
required
Protocol Select Installer Menu>Control Panel>Communication>Central
Station>Phone Numbers>Phone Number n>Protocol.
Note:
Backup Select Installer Menu>Control Panel>Communication>Phone Number
>Phone Number n>Events>Communications>Test Reports.
Note:
Description
The modem is responding to AT commands.
The SIM is valid and programmed correctly.
The SIM has been enrolled on the GSM network.
The SIM PIN code is blocked. Put the SIM into a mobile phone and enter
the PUK code to unblock it.
The module is sending a report to the SMS destination.
The module is sending an audio report from the control to the audio
destination.
The module is sending data.
The module is communicating with the GPRS network.
Good level of the received signal.
There is a problem with the main battery.
There is a problem with the 3.8 V power supply for the GPRS modem
caused by a problem with the main battery.
Use any of the panel protocols (SIA, ContactID).
Use GSM reporting as backup.