GE NX-10 Installer Manual page 203

To Do This
Get a list of zones with
problems
Bypass zones
Read events from the event log
Set a connection to a home
automation device
Switch on X-10 outputs
Switch off X-10 outputs
Activate an auxiliary function
Change your user code
Change another user code
Delete a user code
Start reporting
Stop reporting until system re-
arm
Stop reporting until you start it
again
Register your phone
Register your phone with a new
password
To change language
Send This
zone faults [partition list]
bypass [zone list]
events [number]
events [range]
output [output_number
X10_house_code X10_unit]
on [output list]
off [output list]
switch aux [output list]
user code [new user code]
user code [user number new
user code]
delete user code [user number]
start reporting
stop reporting
stop reporting permanent
register [phone number user
number]
register [phone number user
number Password]
language [language]
Explanation
Sends a list of zones with
problems (like tamper, low
battery, zone lost, etc.) to
your phone. Sending a
command without a
partition list returns
information for all partitions.
Bypasses the specified
zones.
Sends the specified event or
events from the event log to
the phone.
Connects a specified home
automation device.
Switches on an X-10 output.
Switches off an X-10 output.
Changes the auxiliary
function that occurs when it
is activated, for example by
a button on a keyfob.
Changes your user code.
Changes another persons'
user code.
Deletes a user code.
Sends reports from the
NX7002.
Stops reports being sent
form the NX7002 until the
system is rearmed.
Stops reports being sent
from the NX7002 until the
start reporting command is
sent.
The phone is registered with
your alarm system.
The phone is registered with
your alarm system with a
new password.
The language the SMS texts
use is changed. The
available arguments
(languages) are: English,
Dutch, Espanol, Suomi,
Italiano, Polska, Portugues,
Svenska, Francais, Dansk,
Deutsch and Norsk.
Note: no national
characters are to be used in
typed arguments.
NX-10 Installers manual
Example
zone faults 1 to receive fault information
from zones assigned to partition 1
zone faults all to receive the message
with zone faults for all zones
bypass 1 3 to bypass zones 1 and 3
events 1 to read the last (newest) event
from the panel log
events 1 3 to read the last 3 events from
the panel log
events returns the 10 most recent
events
output 2 A 1 to set output two to control
X-10 device with house code A and unit
number 1
on 1 4 7 to switch on X-10 outputs 1, 4
and 7
on all to switch on all X-10 outputs
off 1 4 7 to switch off X-10 outputs 1, 4
and 7
off all to switch off all X-10 outputs
switch aux 1 to activate aux output 1 on
the panel
user code 0101 to change your own
user code to 0101
user code 2 0101 to change the user
code to 0101 for the user 2
delete user code 2 to delete the user
code for the user 2
start reporting
stop reporting
stop reporting permanent
register 32444123456 2 to register the
number 32444123456 to user 2
register 32444123456 1 44aa44 to
register the number 32444123456 to
user 1 with a password 44aa44
language deutsch to change the
interface to German
203