Telephone Number 2 - GE NX-10 Installer Manual

Location 4 is used to select which events are reported to phone N°1. Location 5 is used to select
which partitions are reported to phone N°1. If you do not want dual or split reporting, use location 4
to select all events to phone N°1, and leave location 5 at the factory default of "0". If you want dual
or split reporting, and the split is based on the event type (such as alarm, open/close, etc.), you should
use location 4 to select only those events that should be reported to phone N°1, and you should leave
location 5 at the factory default of "0". If you want dual or split reporting, and the split is based on
partition, you should program location 4 as a "0" and use location 5 to select those partitions that are
to be reported to phone N°1. If no events are to be reported to phone N°1, both locations should be
programmed as "0".
LOCATION 4 - EVENTS REPORTED TO PHONE N° 1 (2 segments, feature selection data)
Segment 1
1 = Alarms
2 = Opening and closings
3 = Zone bypass and bypass restores
4 = Zone trouble and trouble restores
5 = Power fail (AC failure), low battery, power restore (AC restore) , and low
battery bestore
6 = Bell cut, bell cut restore, telephone line restore
7 = Test reports
8 = Start and end programming, download complete and log full
Segment 2 1 = Zone and box tamper
2 = Auxiliary power over-current, and restore
3 = Wireless sensor missing and restore
4 = Wireless sensor low battery and restore
5 = Expander trouble and restore (keypads are considered as expanders)
6 = Fail to communicate
7 = Alarm restore
8 = Tamper restore
LOCATION 5 - PARTITIONS REPORTED TO PHONE N° 1 (1 segment, feature selection data)
Location 5 is used when the events to be reported to a phone number are based on the partition,
regardless of the event. If you use this location, you should program location 4 as "0".
Segment 1
1 = Partition 1
2 = Partition 2
3 = Partition 3
4 = Partition 4

Telephone number 2

LOCATION 6 - PROGRAMMING PHONE N° 2 (20 segments, numerical data)
Phone N°2 is programmed in location 6. A "14" indicates the end of the phone number. Delays of
four seconds can be programmed at any point in the phone number by programming a "13" in the
appropriate segment. The system will always wait for a dial tone unless the first digit of the phone
number is a "13"; in this case, it will only delay. Tone (DTMF) dialling is default. If you want pulse