GE NX-10 Installer Manual page 168

Select Event>Not Ready to Arm and press OK.
3.
The keypad beeps once to accept the change and returns to Event.
4.
Navigate with the
5.
The keypad beeps once to accept the change and returns to Time Unit.
6.
Navigate with the
7.
The keypad beeps once to accept the change and returns to Time.
8.
Navigate with the
9.
OK.
The keypad beeps once to accept the change and returns to Partitions.
10.
The following example sets the event that switches on the output 2 on the IO module 4 as Follow
X10 Commands. The IO module behaves then like a standard X10 device. The X10 unit code
assigned to this output is 5 and the X10 house code is P.
Navigate with the
1.
Scroll to I/O 4 Output 2 and press OK.
2.
Select Event>Follow X10 Commands and press OK.
3.
The keypad beeps once to accept the change and returns to Event.
4.
Navigate with the
5.
The keypad beeps once to accept the change and returns to Unit Code.
6.
Navigate with the
7.
The keypad beeps once to accept the change and returns to House Code.
8.
The list of events that can be selected during IO module programming is as follows:
Table 18. RF receiver output events
Nr. Event
0** Burglary alarm
1** Fire alarm
2** 24 hour alarm
4** Zone tamper
5 Burglary siren
6 Fire siren
7 Any siren
17 Alarm memory
If set to follow condition, these events are one second
**
Note: Events related to a zone alarm are recognized by the event code stored in zone configuration.
Therefore events 0 to 4 require correct zone configuration to work as expected (particularly Control
Panel>Communications>Reporting>Report Codes>Zone Types must be set correctly). For example, in
order for a 24 hour alarm zone to trigger an IO module, the report code must be set to 6 (24 Hour
Burglary) or 9 (24 Hour Non Burglary).
Note: Partition number stored with the alarm event is the first partition the triggered sensor belongs to.
So if the sensor belongs to partitions 1-4 the partition number sent with the event will be 1. It should be
taken into consideration when setting up multi-partition sensors.
keys to Time Unit and press OK. Select Minutes and press OK.
keys to Time, enter 6 and press OK.
keys to Partitions and press OK. Select partition 1 only and press
keys to RF Receivers>RF Receiver 32>Outputs and press OK.
keys to X10 Address>Unit Code, enter 5 and press OK.
keys to X10 Address>House Code, scroll to P and press OK.
Nr. Event
18 Entry
19 Exit
20 Entry or exit
21 Armed
22 Disarmed
23 Ready to arm
24 Not ready to arm
25 Fire
Nr. Event
26 Fire trouble
45** Code entry
46 Key FOB function 1
47 Key FOB function 2
56 Follow X-10 commands
59 Armed in STAY mode
.