Learning-In Io Modules; Learning-In Wireless Sirens - GE NX-10 Installer Manual

memory.
Note: You cannot delete the currently used wireless keypad (the one used for programming).
Note: After deleting the wireless keypad, you have to default it to clear any existing settings. To do this, press
F1+6+Down Arrow simultaneously for a few seconds. The wireless keypad can only be brought back to
defaults (to initiate the startup process) if it is not in the range of an active NX-10 panel, i.e. the signal
strenght icon must show X.

Learning-in IO modules

In order to add a wireless siren or IO module to the system perform the following steps:
Enter the programming mode on the keypad, navigate with the
1.
and press OK.
Note: It is recommended to not learn any devices from a keypad which belongs to a partition different then Partition 1.
Select the relevant module bus ID and press OK. For example, you can select RF
2.
Receiver 32, which is a built-in receiver on the NX-10 panel board.
Select Learn RF Device>Learn Siren/IO, and then select the new siren/IO module
3.
number (Siren/IO 3 to 4) and press OK. The panel starts the learning-in procedure, and
the Learn-in Mode message is displayed on the keypad(s).
Power-up the IO module by connecting a battery pack or inserting batteries (consult the
4.
device's manual for details).
Wait until the LED on the IO module board blinks for 0.5 second.
5.
Trip the IO module tamper switch, simulating the closing of the housing for at least 0.5
6.
second and maximum of 5 seconds, and release the tamper again.
The LED on the IO module will blink for 1 second, ant the keypad beeps once to confirm
7.
the module is programmed.
The IO module is learned-in. Close the IO module housing.
8.
Note: You can delete an IO module using the Del. RF Device menu option.

Learning-in wireless sirens

In order to add a wireless siren to the system perform the following steps:
Enter the programming mode on the keypad, navigate with the
1.
and press OK.
Note: It is recommended to not learn any devices from keypad which belongs to a partition different then Partition 1.
Select the relevant module bus ID and press OK. For example, you can select RF
2.
Receiver 32, which is a built-in receiver on the NX-10 panel board.
Select Learn RF Device> Learn Siren/IO, and then select the new siren number (Siren/IO
3.
1 to 4) and press OK. The panel starts the learning-in procedure, and the Learn-in Mode
message is displayed on the keypad(s).
Power-up the IO module in the siren with tamper open by connecting a battery pack or
4.
inserting batteries (consult the siren's manual for details).
Wait until the LED on the IO module board blinks for 0.5 second.
5.
Trip the siren's tamper switch, simulating the closing of the housing for at least 0.5
6.
keys to RF Receivers
keys to RF Receivers