GE NX-10 Installer Manual page 68

Location Term
2.2.1.1.4 Partitions
2.2.1.1.5 Attributes
2.2.1.1.5.1 Latched
2.2.1.1.5.2 Code Stops Timer
2.2.1.1.5.3 Only if Closed
2.2.1.1.5.4 Only if Open
2.2.1.1.5.5 Inverted
2.2.2 Internal Siren
2.2.2.1 Sounds On
2.2.2.1.1 Phone Line Cut
2.2.2.1.1.1 When Armed
2.2.2.1.1.2 When Disarmed
2.2.2.1.2 Tampers
2.2.2.1.3 Expander Trouble
2.2.2.1.4 Cross Zone Verification
2.2.2.2 Short Blast On
2.2.2.2.1 Arming
Definition
A menu entry that lists the partitions assigned to the
selected output. The selected output can be triggered by
an event on these partitions.
A zone may reside in any combination of partitions. A zone
that resides in more than one partition becomes a
common zone and is reported to its lowest partition
number. A common zone is armed only when all the
partitions that it belongs to are armed. It is disarmed the
moment one of the partitions it belongs to is disarmed.
A menu entry that groups the programmable attributes of
the selected output.
A menu option that causes an output to remain activated
until a code is entered at the keypad.
A menu entry that allows the timer used on programmable
outputs to be reset by entering a valid user code.
A menu option that activates an output after closing time
and before opening time. During these times, codes can be
used to arm/disarm the system. A timer is used to set these
times.
A menu option that activates an output between opening
time and closing time.
A menu option that enables a mode that inverts the state
of an output (normally activated and then deactivated
when an event occurs).
A menu entry that groups options that set the
conditions/events that activate the internal siren. This is a
siren which sounds within the building.
A menu entry that groups events that activate the internal
siren.
A menu entry that groups options that activate the internal
siren when a phone line cut event occurs.
A menu option that activates the internal siren if a phone
line cut event occurs while the system is armed.
A menu option that activates the internal siren if a phone
line cut event occurs while the system is disarmed.
A menu option that activates the internal siren when a
tamper occurs.
A menu option that activates the internal sound when an
expander trouble condition occurs.
A menu option that activates the internal siren during a
cross zone verification time.
A menu entry that groups internal sounder options. Each
option specifies a time at which the sounder blasts. These
options are: Arming, Exit Delay Expired, Closing Kissoff and
Keyswitch Arming.
A menu option that causes the internal sounder to blast
when the system arms.