GE NX-10 Installer Manual page 228

Event message Explanation
First Open The time at which the first partition was opened.
Forced Door The door was opened without an authorisation from the system.
Forced Door Restore See Forced Door event message.
Ground Fault Grounding problem occured.
Ground Fault See Ground Fault event message.
Restore
Keypad Tamper A keypad tamper.
Last Close The time at which the last partition was closed.
Late Close A user disarmed the system after the closing time specified in the panel schedules.
Line Fault Telephone line faults.
Line Fault Restore See Telephone Fault event message.
Listen-in The start of a listen-in session.
Log Full The event log is full and the events must be reported to the up/download software. An
event can also be sent to the central station.
Low Batt Restore See Low Battery event message.
Low Battery The standby battery for the control panel/expansion module is low.
Mains Fail Restore See Mains Failure event message.
Mains Failure The 220 V has disappeared.
Manual Fire A manual fire alarm generated by pressing the keys 1 and 3 on the keypad.
Manual Test A manual test call to the central station.
Medical (Aux2) A medical alarm generated by pressing the keys 4 and 6 on the keypad.
Off-normal Autotest Off normal automatic test result.
Open (disarm) Opening (disarm) by a specific user.
Output Restore See Output event message.
Output Trip An output has been activated.
Over-current An excessive amount of current has been drawn from one of the outputs.
Over-current See Over-current event message.
Restore
PA Panic Alarm A personal attack alarm has been tripped.
Panic Keypad A panic alarm generated by pressing the function key on the keypad.
Partarm Part arm of the system by a specific user.
Pulse count Displays the puse count from a shock sensor zone and the zone number after an alarm.
RAM Check Failure Failure of the RAM check.