GE NX-10 Installer Manual page 78

Location Term
2.4.4.3.3.5 Keypad Tamper
2.4.4.3.4 Power
2.4.4.3.4.1 Mains Failure
2.4.4.3.4.2 Low Battery
2.4.4.3.4.3 Aux Overcurrent
2.4.4.3.5 Tamper/Fault
2.4.4.3.5.1 Box Tamper
2.4.4.3.5.2 Siren Tamper
2.4.4.3.5.3 Zone Fault
2.4.4.3.5.4 Siren Tamper
2.4.4.3.5.5 Phone Line Cut
2.4.4.3.5.6 Expander Fault
2.4.4.3.5.7 Fail to Communicate
2.4.4.3.6 Miscellaneous
2.4.4.3.6.1 Log Full
2.4.4.3.6.2 Autotest
2.4.4.3.6.3 Cancel
2.4.4.3.6.4 Recent Closing
2.4.4.3.6.5 Start/End Programming
Definition
A menu entry that groups the report codes sent for the
keypad tamper event.
A menu entry that groups report codes sent to the central
station when power related events occur.
A menu entry that groups the codes used to report a mains
failure event.
A menu entry that groups report codes sent to the central
station for a low battery event. A restore report is sent to
the central station when this condition is no longer active.
A menu entry that groups the report codes sent to the
central station when an overcurrent event occurs.
A menu entry that groups together the codes used to
report tamper and fault events to the central station.
A menu entry that groups the report codes sent to the
central station when a box tamper event occurs.
A menu entry that groups report codes sent to the central
station when a siren tamper has occurred.
A menu entry that groups report codes that are sent to the
central station when a zone fault condition occurs.
A menu entry that groups report codes sent to the central
station when a siren tamper has occurred.
A menu entry that groups the report codes sent when a
phone line is cut.
A menu entry that groups report codes sent to the central
station when an expander fault event occurs.
A menu entry that groups the report codes sent to the
central station when a fail to communicate event occurs.
A menu entry that groups together the codes used to
report selected other events to the central station.
A menu entry that groups the report codes sent to the
central station when the event log is full.
A menu entry that groups the report codes sent to the
central station when an autotest is performed.
A menu option that enables cancel reporting. A cancel
report is sent to the central station when the system is
disarmed (within the time specified by the dialer delay)
after an alarm.
A menu option that sends a report to the central station if
an alarm occurs within five minutes after the panel has
been armed. The user number that armed the system is
also sent.
A menu entry that groups the reporting codes sent to the
central station when programming starts, and when the
installer leaves programming mode.