GE NX-10 Installer Manual page 69

Location Term
2.2.2.2.2 Exit Delay Expired
2.2.2.2.3 Closing Kissoff
2.2.2.2.4 Keyswitch Arming
2.2.2.3 Output Signal Type
2.2.3 Keypads
2.2.3.1 Sound On
2.2.3.1.1 Phone Line Cut
2.2.3.1.1.1 When Armed
2.2.3.1.1.2 When Disarmed
2.2.3.1.2 Mains Failure
2.2.3.1.3 Low Battery
2.2.3.1.4 Cross Zone Verification
2.2.3.1.5 Tampers
2.2.3.1.6 Expander Trouble
2.2.3.1.7 Emergency Keys
2.3 Codes
2.3.1 4/6 Digit Codes
2.3.2 Installer Code
2.3.2.1 Code
Definition
A menu option that causes the internal sounder to blast
when the exit time expires.
A menu option that causes the internal sounder to blast
when the central station receives a closing report.
A menu option that causes the internal sounder to blast
when the system is armed by keyswitch or armed and
disarmed by keyswitch. There is one blast for arming and
two blasts for disarming.
A menu option that converts the internal siren to accept a
speaker. The built-in 112db siren driver can be converted to
a 1-amp voltage output. The siren can be 15 or 30 Watt
maximum, with an impedance of 4, 8 or 16 ohms.
A menu option that groups keypad buzzer options.
A menu entry that groups events that activate the keypad
buzzer.
A menu entry that groups options that activate the keypad
buzzer when a phone line cut event occurs.
A menu option that activates the keypad buzzer if a phone
line cut event occurs while the system is armed.
A menu option that activates the keypad buzzer if a phone
line cut event occurs while the system is disarmed.
A menu option that activates the keypad buzzer when the
mains power supply fails.
A menu option that activates the keypad buzzer when a
low battery event occurs.
A menu option that activates the keypad buzzer during a
cross zone verification time.
A menu option that activates the keypad buzzer when a
tamper occurs.
A menu option that activates the keypad buzzer when an
expander trouble condition occurs.
A menu option that activates the keypad buzzer for
emergency keys.
A menu entry that groups user code options.
A menu option that specifies whether a four or six digit
code is used.
A four or six-digit code used to program the system. It
specifies the partitions and parts of the system the installer
can access. It can also be used as a standard arm/disarm
code, in which case it becomes user 255.
A Codes menu entry that groups installer code options.
A menu option that sets the user code. This is a series of
four or six numbers that allows access to the system.
NX-10 Installers manual
69