Feature And Report Selections (For Partition 1) - GE NX-10 Installer Manual

LOCATION 21 - DOWNLOAD CONTROL (1 segment, feature selection data)
Location 21 contains the feature selections to control download sessions. The following features can
be enabled or disabled using this location (see the feature definitions on pages 5-11).
Segment 1 1 = On: enables two call answering machine defeat
2 = Reserved
3 = On: requires call-back before download session
4 = Shutdown (can only be viewed from the keypad; must be changed by
downloading)
5 = On: locks all local programming. (can only be viewed from the keypad; must
be changed by downloading)
6 = On: locks programming of all locations associated with the communicator
(can only be viewed from the keypad; must be changed by downloading)
7 = On: locks out download section. (If "On", locations 19-22 cannot be viewed
from the keypad; can only be viewed from the keypad when "Off".)
8 = On: enables call-back at auto test interval
LOCATION 22 - DOWNLOAD CALL BACK NUMBER (20 segments, numerical data)
If a telephone number is programmed into this location, and "Require Call-back" is enabled in
location 21, the control panel will hang up for approximately 36 seconds (ensuring that the calling
party has disconnected), and then call back. The system will always wait for a dial tone unless the
first digit of the phone number is a "13"; in this case, it will only delay. Tone (DTMF) dialling is
default. If you want pulse tone dialling, program a "15" in the segment where pulse dialling should
begin. If the entire number should be pulse dialling, program a "15" in the first segment. Four-second
delays can be obtained anywhere in the sequence by programming a "13" in the appropriate delay
location.
Note: A zero is programmed as a "0".
Warning: You should always check that the callback phone number is accurate before disconnecting.

Feature and report selections (for partition 1)

LOCATION 23 - PARTITION 1, FEATURE AND REPORT SELECTIONS (5 segments, feature
selection data)
Location 23 is used to enable certain features that the user can access or see from the keypad of the
system. In addition, certain communicator reports are enabled in location 23. Each of these features
can be enabled by partition. For additional partition information, see locations 88-109.
If the feature selection location for any partition is left blank, that partition will use this location for
the feature selection. This location contains 5 segments of 8 features each (see the feature
definitions).
Segment 1 1 = On: enables the quick arm feature (for exit and stay mode)
2 = On: enables the re-exit feature
3 = On: enables the automatic bypass feature (of interior zones)
4 = On: enables the silent keypad panic feature (overrides the audible panic
selection)
5 = On: enables the audible keypad panic feature
6 = On: enables the keypad Aux 1 feature (FIRE)
7 = On: enables the keypad Aux 2 feature (MEDICAL)
8 = On: enables the keypad multiple code attempt tamper feature (keypad