Setting Swinger Count; Programming Outputs - GE NX-10 Installer Manual

Set the value of Inputs>Swinger Count to 5. For more information see Setting swinger
7.
count below.

Setting swinger count

The swinger shutdown function allows the selected zone to be automatically bypassed after a
specified number of alarms. To configure swinger count, you must enable the advanced menu. The
following example sets swinger count to 5. This means that any zone for which swinger shutdown is
enabled can be activated five times within one arm period before it is automatically bypassed.
Bypassing a swinger zone also resets the counter for that zone to zero.
Ensure the advanced menu is enabled.
1.
Navigate with the
2.
Enter 5 and press OK.
3.
The keypad beeps once to confirm the change and returns to Swinger Count.
4.

Programming outputs

Figure 14. Outputs menu
Prog Outputs
2.2.1 2.2.1.1
Internal Siren
2.2.2.1
2.2.2
2.2.2.2
2.2.2.3
Keypads
2.2.3 2.2.3.1
keys to Control Panel>Inputs>Swinger Count and press OK.
1 (< Any Siren >)
2.2.1.1.1
Outputs 2 - 4
Same as above
2.2.1.1.2
2.2.1.1.3
2.2.1.1.4
2.2.1.1.5
Sounds On
2.2.2.1.1
2.2.2.1.2
2.2.2.1.3
2.2.2.1.4
Short Blast On
2.2.2.2.1
2.2.2.2.2
2.2.2.2.3
2.2.2.2.4
Output Signal Type
Sound On
2.2.3.1.1
2.2.3.1.2
2.2.3.1.3
2.2.3.1.4
2.2.3.1.5
2.2.3.1.6
2.2.3.1.7
Event
2.2.1.1.1.1
2.2.1.1.1.2
2.2.1.1.1.3
2.2.1.1.1.4
2.2.1.1.1.5
2.2.1.1.1.6
2.2.1.1.1.7
2.2.1.1.1.8
Time Unit
Time
Partitions
Attributes
2.2.1.1.5.1
2.2.1.1.5.2
2.2.1.1.5.3
2.2.1.1.5.4
2.2.1.1.5.5
Phone Line Cut
2.2.2.1.1.1
2.2.2.1.1.2
Tampers
Expander Trouble
Cross Zone Verification
Arming
Exit Delay Expir ed
Closing Kissoff
Keyswitch Arming
Phone Line Cut
2.2.3.1.1.1
2.2.3.1.1.2
Mains Failure
Low Battery
Cross Zone Verification
Tampers
Expander Trouble
Emergency Keys
Alarms
Arm/Disarm
Communications
Keypads
Sirens
Tamper/Fault
Tests
Miscellaneous
Latched
Code Stops Timer
Only if Closed
Only if Open
Inverted
When Armed
When Disarmed
When Armed
When Disarmed