GE NX-10 Installer Manual page 243

Open the panel housing or the keypad enclosure and connect the mini-USB cable
6.
connector to the mini-USB socket on the panel (see Figure 1, position I ) or on the
keypad board.
If the NX-9104 VVMIQ module is installed, disconnect the power supply (both mains
7.
and battery), disconnect the ribbon cable connecting the VVMIQ module with the control
panel, and reconnect the power supply.
Click Refresh button in the Flasher interface. An additional new port will display in the
8.
Available Ports list, for example, COM 5. Under normal circumstances, it is the COM
port with the highest number, and it gets selected automatically. Select the new port in the
list, if necessary.
In the Flasher application, select the element you want to upgrade (Control board, GSM
9.
module, Radio module or Keypad), click the "..." (Browse) button next to it, and open the
appropriate *.FDK file for this element on your computer.
If you like to verify if the new file contains a different firmware version than the one
10.
already programmed in the panel or the other module you want to update, click Verify to
compare the contents and to display a status message.
Click the Program button. The upgrade operation starts, and the status bar displays
11.
progress. Also the keypad displays progress messages. After all data is copied, "Flasher
success" message displays on the computer.
Repeat steps 8 to 10 for all the modules you want to upgrade.
12.
Unplug the mini-USB connector from the board.
13.
If the NX-9104 VVMIQ module was disconnected in step 7, disconnect the power
14.
supply, connect the VVMIQ ribbon cable, and then reconnect power to the panel.
Close the housing.
15.
Start installer mode and enable the previously disabled tamper switch using the menu
16.
(select Enabled in step 3).
IMPORTANT: After the Radio Module is reflashed, it must be defaulted or fully programmed with the NX-586E direct
connect module with the previously stored sensor configuration.
NX-10 Installers manual
243