GE NX-10 Installer Manual page 194

Report type
HomeText Control
When HomeText control is
enabled, you can control your
alarm system by sending SMS
text messages from your
mobile phone.
Note: Set up phone 1 and
then use the SMS
commands to register
more phones
TCP/IP network connection
Information Menu Option
required
User code User Menu>Users>User n>User Code
Note: In order to be recognized by the system, every HomeText user
must have a valid user code configured in the control panel, otherwise
the system will not accept a command. Any attempt to register, or set
up, a HomeText user without assigned user code will cause sending
the "Unauthorised, access denied" SMS message by the system.
User number NX-7002 Module>Reporting>HomeText>Users>HomeText User
n>System Control>User Number
Enable HomeText Select NX-7002 Module>Options>HomeText>System Control>Home
Control Text Control>Enable.
Select NX-7002 Module>Reporting>HomeText>Users>HomeText User
Set up the user
n>System Control>Password
password
The user must Select NX-7002 Module>Options>HomeText>System Control>Password
enter a password Always Required>Enable.
before sending a
HomeText
command
Commands are Select NX-7002 Module>Options>HomeText>System Control>Only
accepted only Registered Phones>Enable.
from HomeText
phone numbers.
Select NX-7002 Module>Reporting>HomeText>Registered Phone
Allow the user to
Access>Users n
send HomeText
commands from Note: Only users included on this list are granted rights to send
a registered HomeText commands to the system. Removing a user from this list
phone only. suspends all user's rights to send HomeText commands, including Any
Phone Access privileges.
Select NX-7002 Module>Reporting>HomeText>Any Phone
Allow the user to
Access>Users n
send HomeText
commands from Note: Sending a HomeText message from the unregistered phone
any phone. requires the following syntax:
[Registered Phone Number] [password] command [values]
GPRS Access Point Select NX-7002 Module>Options>Network>GPRS APN.
Number
PPP Login Select NX-7002 Module>Options>Network>User ID.
PPP Password Select NX-7002 Module>Options>Network>Password.