Table of Contents
Advertisement
20
•
Opening and Closing Reports
•
Latchkey Reports
•
Notify by Exception Reports
Pager Messages
When an event is reported on a numeric pager, the following information is included:
Although all three types of information can be reported on your pager, your pager service deter-
mines how the information will actually appear.
Event Code in Page
This part of the page let's you know what has happened.
Code
009
A sensor has been restored to its non-alarm state
111
System has been disarmed
115
Sensor test exit
118
System trouble has been fixed
119
System alarm condition has been cancelled
222
System armed to Level 2—STAY
333
System armed to Level 3—AWAY
555
System phone/sensor test
888
System has a trouble condition
999
System is in alarm condition
If a user arms the system to level 3 (AWAY) the pager will report that the system was armed to
level 3 (333). However, if the Auto Stay Arming feature is enabled and the user does not exit
the premises, the arming level will revert to level 2 (STAY) without notifying the pager. Refer to
the User Sheets in Appendix A to see whether this feature is on or off.
Sensor Number or User Number in Page
This part of the page let's you know who or what is causing the event.
Code
000
System event not caused by a sensor or user
001 — 096
Sensor numbers 1 through 96
600 — 829
User codes 00 through 229 used
846
System Master code used
847
Installer code used
848
Dealer code used
850
Quick Arm used
851
Keyswitch sensor used
852
System armed itself because it is being serviced or powered-up
Event Code
Last four digits of central
station account number
Sensor number or user number
Figure 8. Pager Messages
Indicates
Indicates
Security Pro 7000
Advertisement
Table of Contents
